• Cross Point kit includes 4 points and 8 mounting screws.
• Each aluminum section is cut to 1-1/2″ L – ends are angled at 90° for perfect right angle fit
• The 4 points are pre-drilled with two holes in each section for easy mounting
• T-track SOLD SEPARATELY
• Made in USA

Product Description
Our 4 piece T-track cross points allow you to easily make T-track intersections. They work especially well on wooden drill press & bandsaw tables, and can be used to build home made oval jigs… More >>

T-TRACK CROSS POINTS – FOR 1/4″ MINI TRACK

• All aluminum stop for 1/4″ mini T-track slot
• Flips out of the way if you need to make an odd cut in the middle of the run
• Easy to use – just slide onto your t-track
• Set to desired measurement and make repetitive cuts without re-measuring each time.

Product Description
The Flip Stop is easy to use. Just slide it onto your T-track and set it up to the measurement you need. You can make the exact cut repeatedly without the hassle of measuring each time. If you do need to make an odd or special cut, just flip the stop up, make that special cut and then lower the stop again to continue making your repeat cuts without having to re-measure…. More >>

FLIP STOP – 1/4″ FOR MINI T-TRACK

• Dual track combines Miter T-Track and Mini T-Track into one solid extrusion.
• One side of the track accommodates a standard 3/4″ x 3/8″ miter gauge with or without T-slot.
• The other side fits a standard 1/4″ x 20 hex head bolt, for setup of feather boards, stops, etc.
• This track will also accept our T-bar – Sold Separately
• Primarily used on router tables, table saw extensions and drill press tables. Made in USA

Product Description
This track can be inlayed into any router table or table saw extensions to maximize the tables capabilities. The track gives both a track to slide jigs and miter bars in as well as a hold down slot for toggle clamps and other hold downs. MADE IN USA… More >>

48″ MITER MINI T-TRACK/STANDARD MITER T-TRACK COMBO